A1/A1MINI挤出机散热6cm/4cm风扇卡件

A1/A1MINI挤出机散热6cm/4cm风扇卡件

Boost
15
36
5

Print Profile(1)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 25% infill
0.2mm layer, 2 walls, 25% infill
Designer
3.7 h
4 plates

Open in Bambu Studio
Boost
15
36
5
3
71
4
Released

Description

通过卡子对A1/A1MINI工具头添加散热风扇,一开始是6025设计的,后来有人觉得太大了,加上3cm有人设计了,所以只是添加了4cm风扇设计(4cm卡件添加了超45度的导风槽,悬垂性能不足会下垂),4cm其实是这个风口利用率最高的了

效果如图,均在30度箱内温度测试

利民6025(30%pwm) 无风扇

 

3元包邮的4020(100%/7000r)

 

按每加1度室温,至少上升1度,在45度封箱下挤出机温度上百,推荐使用7000r以上的4cm或10000r以上的3cm风扇进行散热

 

Machine flipping:

Add a cooling fan to the A1/A1MINI tool head through a clip. Initially, the design was 6025, but later some people thought it was too large. In addition, someone designed a 3cm fan, so only a 4cm fan design was added (the 4cm clip added a super 45 degree air duct, which will sag if the suspension performance is insufficient). In fact, the 4cm fan has the highest utilization rate of this air outlet

 

For every 1 degree increase in room temperature, increase by at least 1 degree. When sealing the box at 45 degrees, the extruder temperature should reach over 100 degrees. It is recommended to use a 4cm or 3cm fan with a capacity of 7000r or more or a 3cm fan with a capacity of 10000r or more for heat dissipation

 

Comment & Rating (5)

Please fill in your opinion
(0/5000)

请问安装时用几毫米的螺丝呢
The designer has replied
0
Reply
自攻看风扇,M3加螺母话,是风扇厚度加4的6mm薄平头M3螺丝
0
Reply
您好,4CM版本是4010还是4020?
The designer has replied
0
Reply
默认是4020,也可以安装4010,4cm孔通用的,不用装饰外壳或垂直缩放一下外壳就行
0
Reply
安装从上向下卡入,推荐使用自攻螺丝或bso等对锁安装
0
Reply
No more