Control Cabin Trinket for A1 series by yunusalih

yunusalih

3D Printer>3D Printer Accessories

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm nozzle, 0.08mm layer, 4 walls, 15% infill

Designer

2.3 h

1 plate

5.0(1)

Boost

Released

Description

Its a crane cabin to turn your A1 series into a fun little crane or something along those lines.

It prints flat and you fold everything in and use double sided tape to stick it on your unit.Let me know if you cant figure it out. You also need to use any sharp object to remove the brims that it has all around to prevent warping.

Also door is articulating with the thin brim-like structure if you fold it inside the housing.

I am curious about your opinion so let me know in the comments!

Comment & Rating (5)

@STLDad6

Print Profile

0.2mm nozzle, 0.08mm layer, 4 walls, 15% infill

super cute

The designer has replied

@yunusalih

Thanks for the print! I just noticed, i should have explained the door part better. The thin layer between the main body and tje door was actually the joint between them and you fold the door inside the body so its my bad on that part and i would update the photos to explain it better.

@Scaveng3er509

I made a design of a similar idea but just looks a little plain, where the cabin actually uses the hole on the cutter arm to hold it in place, but mine sits on top of that rather than where yours is. I think a design that uses that hole rather than tape, which some might find off-putting, works well, so maybe consider it? Up to you. Its still a great design though.

The designer has replied

@yunusalih

it would be a lot cleaner looking but since i made the design foldable, i couldnt figure out a way to do a mounting point because back of the print lays flat to print bed. Thanks for the suggestion though! I will think of the ways to do a mount. Gave your design a like and download aswell.