A simple hairpin designed to be usable straight off the build plate with *no snagging points using the 0.2mm nozzle. While it is possible to print using the 0.4mm nozzle, some light sanding will be necessary to remove snagging points. Recommended to print at 100% infill for safety when the stick is bent, resulting in bending before breaking or snapping.

This was a project request from a co-worker of mine for use while she sleeps. I took the time for her to nit-pick every facet of the design to get something truly useful and beautiful. I hope the smile it brought her can be brought to others through the publishing of the model here.

*pay attention to any points on the top-surface where the nozzle retracts from the model, I had one pin have a small snag point there, nothing a small snip with some side-cutters didn't solve.