A low poly art of a lion in black and white.

Filament used:

PLA Jayo Black Matte

PLA Eryone Jade White

Swap Instructions:

• Start with Black
• At layer #7 swap to white

Use a white that doesn't fill to fast to get a better gradient, so generally cheap filaments are better.

To use it without AMS:

• Use the No-AMS profile
• Slice the profile
• On the right go to layer 7
• Right Click > add Pause > Ok 
• This will Trigger a manual Pause at this Layer where you can then change the filament

Made with HueForge

If you need an easy stand for the picture you can use this:

It only uses 17g filament and is printed in 37 minutes 

https://makerworld.com/en/models/470314#profileId-379805