Awesome shock absorber keytag!
This one might be a little tricky to assemble
All you need is printed parts, around 20,5cm of filament for spring, superglue, scalpel and a lighter
Step 1:
Glue together parts 2 and 4 (on the picture)
Step 2:
Make the piston rod as round as possible by cutting glued edges with scalpel
Step 3:
Use part 5 as filament bend guide. First heat a small part on one of the ends of 20,5cm piece of filament with lighter and put it on the guide tower (part 5). Heat up next parts of filament to make it bend around and after spring is cold, take it off the guide tower.
Step 4:
Put the spring on the piston rod (part 2 and 4) and put it in part 1. Use a little amount of glue on part 1 so it wont drip inside and put part 3 on part 1 to glue them together
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.