This is a Mask, Hat and Wig Stand. The design emphasis was minimalism and speed of printing.

In this remix I have separated the parts so that the thing can be printed on a 220 x 220 build plate at 100% or on a 200 x 200 build plate at 95%.

Conversely the V2 protoype was a little large for my Batman Cowl so therefore I probably should have reduced to 95%.

Parts are a reasonably tight interferance fit but can be glued for greater security.

Printing Instructions:

1.The things were printed fast using a 0.8mm nozzle, 0.6mm layer height and @40mms. 1 perimeter and 7% infill.

2.Further speed reductions may be achieved with only printing bottom layers and rely on the infill for rigidity. Average print time at these settings was approx. 35 minutes.