This is a remix of my Dyson accessory holder but designed to retain the node articulation but printed in one single print.

The V2 is probably more visually elegant and efficient to print - this version was has much a design challenge rather than trying to totally reinvent the thing.

Printing Instructions

Printed @0.2 resolution on a Ender 5 with a 0.4 nozzle and prototyped on a CR10S with a 0.8 nozzle. The thing was printed with 3 perimeters and 25% infill to provide some strength..

The connector node requires some custom support as it is not flat to the bed. The rest of the thing does not require any additional supports (see uploaded image).

Being one single print, prints times are quite long. The prototype printed with a 0.8 nozzle took 8 hours and the 0.4 nozzle version 17 hours.