Eredin from The Witcher, with his famous quote from Gwent.

Do NOT adjust the thickness (Z) in your slicer!! The layers will not come out right. You CAN adjust the other dimensions (X,Y) though to make it bigger or smaller, just not the thickness.

These were my settings and colors for my print that you see in the picture. Your results may vary depending on the filament you use and if you have your own HueForge profile saved with different settings. I'll be really happy to see your results if you print with different filaments :)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Nozzle: 0.4

Filaments Used:
PLA BambuLab Matte Charcoal Transmission Distance: 0.6
PLA BambuLab Matte Marine Blue Transmission Distance: 2
PLA BambuLab Matte Lemon Yellow Transmission Distance: 4
PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:
Start with Charcoal
At layer #15 (1.28mm) swap to Marine Blue
At layer #17 (1.44mm) swap to Lemon Yellow
At layer #20 (1.68mm) swap to Jade White for the rest.