Chest / Case with hinges and lock || No support
Copyright Claim
Chest / Case with hinges and lock || No support
Boost
32
62
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
6.6 h
3 plates
Boost
32
62
2
0
22
8
Released
Description
Chest with hinges. Everything is in profile print. No need to buy bolts and nuts.
Chest size is 10x10x10cm
Hinges size 5mm you can use metal bolts size m5.
Top part is pritned upside down. Be sure heatbed is really clean before printing top part.
First assemply can be a little rough and hinges can feel too tight but when you finish assembly and open/close chest few times its get smoother.
Comment & Rating (2)
All
Hello, do you think that instead of PLA, I can use a PETG filament? And if yes, should I change anything? I'm still a newbie, so would highly appreciate if you could help me a bit. Thanks! ^^
The designer has replied
0
Reply
Yes of course. Petg is even better than normal PLA. Just use the right heatbed and nozzle temperature for PETG.
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld