Car Seat Crevice Organizer

Both Passenger and Driver seat variations included.

The model is in two parts.  They must be glued together.  There are peg and holes to help line up the two pieces when glueing.

These car seat crevice trays are thinner than the varients I have tried downloading.  I found the ones I downloaded a little too wide and were uncomfortable when I sitting in the car seat as it was pressed up against me.  The ones with the cup holders were even more uncomfortable.  Which is why I designed these thinner versions without cup holdes … they simply protect from dropping things down beside the seat and center console, and add a little bit of storage.  There is a little hole in the front of them to allow a cable to go inside in case you wanted to have your phone is the organizer plugged into power.

I printed in PETG and used dollar store epoxy to glue together.  The little pegs held line up for gluing.  Be sure to dry fit the pegs to the holes before gluing to make sure you can get the pegs easily into the holes.  It is a tight fit with PETG, a little looser if printed in ABS.  The pegs are meant as assistance in lining up the parts during gluing only and not meant to hold the pieces together.

No supports necessary if you print the parts standing up.