Dragon Quest Slime
Copyright Claim
Dragon Quest Slime
Boost
41
56
7
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
45 min
1 plate
0.2mm layer, 2 walls, 15% infill
2.5 h
1 plate
Open in Bambu Studio
Boost
41
56
7
2
80
68
Released
Description
Just a basic little slime. I use it as a ring holder.
Includes both a full slime as well as a “weighted” one with room to add weights into it (I used wheel weights). Sized to 50mm wide
Note: This model has A LOT of triangles so will take a bit to load up in a slicer.
Comment & Rating (7)
All
Boosted
Print Profile
0.2mm layer, 3 walls, 15% infill
too cute. lovely print quality with 0.2mm and jade whote
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Amazing print, very easy and looks well! 😁
I colorized it to look like the original DQ Slime and uploaded the profile, so other people don't have to do all the work again 😊
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 15% infill
printed 25 my kids loved them
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
might benefit from supports had some sag
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld