The Stand Stephen King movie poster fridge magnet
Boost
11
9
4
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
Open in Bambu Studio
Boost
11
9
4
0
9
6
Released
Description
The Stand Stephen King movie poster fridge magnet.
Commisioned by user ldickinson01 who has kindly agreed to allow the model to be shared on Makerworld.
Measuring 65mm wide by 95mm high by 5mm deep
4 colour AMS print, using black, white, lemon yellow and orange.
This needs 4x 8mm diameter by 2mm deep magnets, the magnets push into the model after printing, no need to pause.
NOTE - The magnets are designed to be a tight fit. The best way to insert them is to line up a magnet with a hole then place the model on a hard flat surface facing up, with the magnet on the hard surface, then press down firmly on the model. The magnet will snap into place. Repeat for each magnet.
Comment & Rating (4)
All
Print Profile
0.08mm layer, 2 walls, 15% infill
Very nice!
The designer has replied
1
Reply
Thank you :-)
(Edited)1
Reply
I love your work ever think of doing any star wars
The designer has replied
1
Reply
I'd love to do star wars and I've been thinking about it since I started, however I like to keep the posters as close to original as possible and unfortunately all the star wars ones have too many fine details that would be impossible to capture.
I may figure out a way to remix them without losing too much detail someday 🤷🏼♂️
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld