Back to the future movie poster fridge magnet
Boost
40
41
7
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
4.9 h
1 plate
Open in Bambu Studio
Boost
40
41
7
3
18
7
Released
Description
Back to the Future movie poster fridge magnet.
Measuring 66mm wide by 96mm high by 5mm deep
This model requires 2 x AMS units to print
7 colour Bambu AMS print, using Black, White, Blue, Red, Ice Blue, Yellow and Orange,
This needs 4x 8mm diameter by 2mm deep magnets, the magnets push into the model after printing, no need to pause.
NOTE - The magnets are designed to be a tight fit. The best way to insert them is to line up a magnet with a hole then place the model on a hard flat surface facing up, with the magnet on the hard surface, then press down firmly on the model. The magnet will snap into place. Repeat for each magnet.
Comment & Rating (7)
All
Print Profile
0.08mm layer, 2 walls, 15% infill
Great job, i ilke it !!
The designer has replied
0
Reply
Thanks Allan :) Looks Great
0
Reply
are the colors listed the initial order? if so, has the standard pause to change?
The designer has replied
0
Reply
I'm sorry this one doesn't support pause to change.. It does need 2 AMS units to print, I do always say in the description if a model supports pausing... Though I should make it clearer which ones need 2 AMS units.
Joker, Dredd, Back to the future and Escape from New York all need a second AMS I'm afraid
0
Reply
no problem, thanks!
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
TOP
1
Reply
Boosted
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld