Great design. But could use some improvement. It's wider then the standard painters tape and the board hooks don't fit tight against the board so it tends to fall off. Please make these changes to make it truly great.
thank You for Your input. i can shorten the holder and will upload a new version in the next days. when i printed the part, the hooks were tight enough, wich nozzle/material did You use?
Polymaker PLA and standard .4 nozzle on P1S.
To clarify... the distance from the back of the flat part that goes against the board to the back of the hook is what I am suggesting to be adjusted. So that when you hang the hook on the wall it would grab on a little bit , not just hang on.
The length of the tape hanger is a separate item.