This is a replacement magnetic bracket for the RedSea ATO+ bracket.

NOTE:

• A pause is needed to insert the magnets at the first top layer that is on the Wetside and Dryside magnets. This is typically around layer 20 or 27 depending on your slicer. I printed this on my P1S and the magnets stuck to the bed and the printer sealed them in perfectly.
• If you are printing this with magnets, please make sure you use sealed or waterproof magnets.
• Each Wetside / Dryside holds two magnets.
• The print bed side is the thinnest. Make sure to match the polarity of the magnets if you want your print bed side facing out.

Supplies:

• Magnets used are 30mm x 1.75mm. Amazon Link