Search models, users, collections, and posts
simulation pig model
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
30
66
6
2
91
35
Released
Description
This is a simulation of a pig model, I tried to print the model upside down because it is too small so there are some imperfections in its ears, but the rest of the details are well presented and it can act as a fine decoration, I used a 0.4 nozzle, if the 0.2 print I think it would be better!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)