Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 95.76x170.24mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.3mm and the Actual Depth is 2.4mm

Filaments Used:
    PLA BambuLab Basic Black Transmission Distance: 0.6
    PLA BambuLab Basic Red Transmission Distance: 4
    PLA BambuLab Basic Yellow Transmission Distance: 6
    PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #7 (0.64mm) swap to Red
    At layer #16 (1.36mm) swap to Yellow
    At layer #17 (1.44mm) swap to Jade White

This slider is set higher than the mesh depth.  It is not affecting your final mesh.  Consider removing it.
    At layer #27 (2.24mm) swap to Black for the rest.