Creality CR6-SE Raspberry Pi Case
Copyright Claim
Creality CR6-SE Raspberry Pi Case
Boost
1
2
0
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
3.1 h
1 plate
Open in Bambu Studio
Boost
1
2
0
0
2
0
Released
Description
I changed the design so that it fits perfectly on a Creality CR 6-SE. I enlarged the hole on the SD card so that you could easily take it out. As an alternative, I have attached a cable holder for a Pi-Cam so that it is not accidentally pulled from the bed.
Support is only needed on the bracket. The cable holder can also be printed without.
Even after several hours of printing, I never had any problems with PLA.
CR 6 PiCam Holder: https://www.thingiverse.com/thing:4842559
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)