I really liked this model but it was just a touch too small for my particular scoop. I've moved over to printables and I didn't see this here so I figured I would upload my version and credit the original on thingiverse.

I increased the outside width by 7mm and the depth (front to back not top to bottom) by 4mm. It fits perfectly now and has a little bit of room around it so I'm not fighting to put it in or out.

Printed in PLA with 5% honeycomb infill (should not matter at all though I did lightning first and the walls were totally hollow so I figured I'd give a little something in there)

I attached mine with hot glue and the old painter's tape trick. Working great!

Here is a link to the product on Amazon as of Nov 8, 2022.

Original design by phantomedChai

https://www.thingiverse.com/thing:5272548