Mario Flame Toss Poster + Glow in the Dark! by tbosley02

tbosley02

Art>2D Art

Print Profile(3)

All

P1S

P1P

X1 Carbon

X1E

0.08mm layer, 2 walls, 100% infill

Designer

1.3 h

1 plate

5.0(1)

0.08mm layer, 2 walls, 100% infill

Designer

4.4 h

1 plate

0.08mm layer, 2 walls, 100% infill

Designer

2.2 h

1 plate

Open in Bambu Studio

Boost

Released

Description

Mario Flame Thrower Poster created with HueForge. I have also added some images of how it looks with glow in the dark filament - I think it looks pretty cool. The one image shows what it looks like with a UV LED strip, the others are the glow effect. Simply swap White for Glow.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
Creality Black PLA

Hatchbox Red PLA

Hatchbox Orange PLA

Bambu White PLA

Swap Instructions:
Start with Black
At layer #13 (1.12mm) swap to Red
At layer #18 (1.52mm) swap to Orange
At layer #19 (1.6mm) swap to White for the rest. (alternatively, use Glow filament)

Comment & Rating (9)

@Miclongman

Boosted

any luck ? as i cant wait to print these :) there sooo nice

The designer has replied

@tbosley02

Unfortunately, when scaling to that size it doesn't look good. The aspect is all out of whack at that ratio. Sorry, I was thinking I could do it. Best I can do is 100x135 or 150x202.

@Miclongman

Boosted

Replying to @tbosley02 :

that would work :) ca you do both of them sizes please :)

@tbosley02

Hey, I saw your other reply after I sent the last one. I have added two new profiles, one with 150 and the other with 100. Hope that helps! Sorry for the delay. Hover over the print profile and you should see my note on the sizes.

@Miclongman

Boosted

and could you make this one 100x100 please :)

The designer has replied

@tbosley02

Do you want it 100x100 or 150? You have two comments here - I can do that this evening but just let me know which one you want.

@Miclongman

Boosted

i would love one of each if that’s not to much to ask as both my kids want difrent sizes :)

@Miclongman

Boosted

Print Profile

0.08mm layer, 2 walls, 100% infill

it turned out really well :) cant wait to print the middle size one :) thanks again

@Miclongman

Boosted

love this print but is there a chance you can scale it down to 150 on the X and the rest can be what ever for it to work :) as im just building a little project :)

No more