These Funko skadis mounts are a great way to display your collection of Funko Pops. Each one has a small raised lip so that they prevent them from sliding off, and the mounts lock in securely to your ikea skadis pegboards.

I have uploaded multiple options for printing these mounts.

One with the clips attached and has a built in 2 layer brim on the clip legs to prevent them falling over while printing (this happened many times to me even with a standard brim, so I added these in and no more issues) this is my recommended way of printing these. The 2 layer brim is very easy to just break off(careful if breaking as to not put strain on the clips) or cut off with scissors or an exacto/utility knife(This is the way). I still use a normal brim also just to prevent warping on the mount itself, but that is up to you. The included 3mf has a brim and gyroid infill.

Second option is the file without the 2 layer brim built in on the legs, this is possible but I had many failures. If you go this route I would use a normal brim still and don't say I didn't warn you if you have failures. The included 3mf file for the no 2 layer brim has a 0 distance normal brim set, and gyroid infill. This is NOT the way I would recommend printing these, but I just wanted people to be able to make that choice for themselves.

Lastly, the way that I think is second best to print them is with clips printed separately and then glued into place with super glue. This option works well but does give quite as snug of a fit into the skadis, but is still a good working option. The included 3mf for these uses a brim and gyroid infill.

All of these are fine printed out of PLA and at a .2 layer height.

I know they have other size boxes, but these are all my son had. If you need other sizes message me and I will see what I can do.

Hope you enjoy these and if you do please leave a comment and a picture if possible!