Why didn't SIMPSON provide proper length handles so this is usable while standing upright?

look at the stock photo the wheels are only 10 inches tall and you'll realize then how low the machine handles are from the factory!

bending over all the time was killing my back, I am sure that most other people suffered as I did so I made this handle lengthen-er to adjust the height of the handle up to a comfortable level.

consequently this allows the pressure wand/gun to be held in a different orientation so that it does not fall off the holder like it did when the machine handle was so low to the ground

Improving working conditions, and working comfort for optimum performance!

so if you are taller than 3ft 7-1/2inch or don't do all your power washing on your knees you need handle extenders!

I chose this power washer after watching this video…

Prints one at a time laying flat on 256x256 size build area.

Print with as many walls and top bottom layers as you think you need

may need supports and brim depending on your build surface.

printing too fast may cause it to warp and pull up with heavy layer and wall loop numbers.

You will need to provide your own screws, I recommend ½-20 screws washers and lock nut.

I am 6ft tall and I think the handle is at a comfortable height for handling the machine.

also the wand never would stay right in the handle as demonstrated in the product photo but at this height it will stay better but then you will probably want to print my other model to keep the tip from getting caught on the wheel when moving the machine or caught in the control wires of the machine when hanging up the pressure wand/gun on the handle as I have it in the picture.


you can find my Nozzle guide to add to your machine here…
https://www.printables.com/model/846694-simpson-power-pressure-washer-nozzle-guide-for-pre

I got my pressure washer from my local tractor supply

https://www.tractorsupply.com/tsc/product/simpson-powershot-3-600-psi

these extenders probably work with several other models as well

Remember to upload a make. you can get up to 10 Prusameters for Uploading a make.