This is truly an ergonomic aid because moving the machine with the spray gun hung on the handle is difficult and awkward with out it, because the nozzle tip will block the 10 inch wheel from spinning freely.

This helps keep your nozzle from bumping into your tire while moving your machine and helps keep it from ripping off your control wires next the engine also. so you can effortlessly place the nozzle end of the spray gun between the engine and wheel were it stays nicely in place when you hang up the spray gun on the handle.

It helps keep the spray gun in place on the handle better than without it too.

This model installed only works after you have my handle extenders added to your machine.

You will probably want the other handle extender model to keep your pressure wand in place.
You can down load it here…

https://www.printables.com/model/846684-simpson-power-pressure-washer-handle-extender

I printed mine from JAYO mate PLA. I have not ran it for a very very long time yet but it has not melted warped or even gotten soft from engine heat even though it is so close.

you may want to add a zip tie to the front to bar if you print it with out enough wall thickness or weak material that does not clip on well to the front bar.