Scuderia Ferrari LightBox
Copyright Claim
Scuderia Ferrari LightBox
Boost
60
94
22
Print Profile(4)
0.2mm layer, 2 walls, 15% infill
Designer
3.5 h
1 plate
0.2mm layer, 6 walls, 25% infill
Designer
48 min
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
8 min
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
3.6 h
1 plate
Boost
60
94
22
2
209
127
Released
Description
Scuderia Ferrari Light Box
4 files to print with 1 AMS Unit or 2 AMS Units:
1 AMS Unit: File "Red_Only" + "Four_Colors" + “Ferrari_LightBox_Back”;
2 AMS Units: File "Ferrari_Lightbox_Front" + “Ferrari_LightBox_Back”.
Discover our others exciting 3D models: here
Materials and tools:
- a glue gun
- aluminum tape for better reflection
- led strip
- soldering iron (depends on the board that your using)
RECOMMENDATIONS
- use a textured PEI sheet
- use the print profile of the print
- make a hole for the USB strip wherever you like it best with a soldering iron, drill or in the slicer
- use the aluminum tape on the inside of the backplate to help with light diffusion
Comment & Rating (22)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
belloooooo
The designer has replied
0
Reply
Forza Ferrari!
0
Reply
How would you pass the led strip from the bottom to the top part?
The designer has replied
0
Reply
You can make a small hole with Bambu Studio, negative part feature
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
really good
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed gray very thin front though
0
Reply
stl
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld