Backup Camera holder for Type S 6.8" touch monitor
Copyright Claim
Backup Camera holder for Type S 6.8" touch monitor
Boost
0
1
0
Print Profile(0)
Add the first print profile to earn points
Boost
0
1
0
0
0
0
Released
Description
Holder made to perfectly snap fit over the contorts of this Type S 6.8" back up camera monitor, to allow for most phone holders to grab the device.
I printed it in PLA and it was a strong snap fit, but other filaments may work better.
Category: AutomotiveComment & Rating (0)
All
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld