擦板作者地址：Build Plate Cleaner 来自 K-Studio.ca - MakerWorld

原作者的擦板由于是单个的比较麻烦，做了3连底座。第一个槽位是LAC胶水和擦板，第二个槽位是水喷雾和湿擦板，第三个是放备用无纺布的槽位和干擦板。

使用顺序是2-3-1。2号位水喷雾喷板子，然后使用擦板擦干净。然后3号位擦干板子。1号位喷LAC胶水，如果喷的近会导致发白可以使用擦板进行抹开。无纺布槽位用于三个槽位的更换。

Author address: Build Plate Cleaner from K-Studio.ca-MakerWorld

The original author's rub board is more troublesome because it is a single, and three bases are made. The first slot is LAC glue and wipe board, the second slot is water spray and wet wipe board, and the third slot is a spare non-woven fabric slot and dry wipe board.

The order of use is 2-3-1. Spray the board with water spray at position 2, then wipe it clean with the eraser. Then position three dries the board. Spray LAC glue on position 1. If the spray is close enough to cause whiteness, use an eraser to remove it. The non-woven slot is used to replace three slots. Author address: Build Plate Cleaner from K-Studio.ca-MakerWorld

The original author's rub board is more troublesome because it is a single, and three bases are made. The first slot is LAC glue and wipe board, the second slot is water spray and wet wipe board, and the third slot is a spare non-woven fabric slot and dry wipe board.

The order of use is 2-3-1. Spray the board with water spray at position 2, then wipe it clean with the eraser. Then position three dries the board. Spray LAC glue on position 1. If the spray is close enough to cause whiteness, use an eraser to remove it. The non-woven slot is used to replace three slots.