This is the Hammer Brother Mecile model by BlackCrest Miniatures. I tweaked it to be slightly smoother along a few hard edges to make sure it would have smooth print lines in what might have been a couple problem areas if scaled larger than 100%.

Details:

• This is a Orca Slicer file. It is listed with the STL files. I highly recommend using Orca for miniatures, as it gives you more options for supports, allowing for more controlled and less filament heavy options. It is just as easy to use and can connect to your printer all the same as Bambu Studio.
• 02 Nozzle Size print. Doable with 04, but you will lose a little detail, and you may have to modify supports.
• This was done with Bambu PLA-Matte grey. I wouldn't recommend the Matte for miniatures, as it is very brittle. Most normal PLA or PLA+ will print stronger. ESun PLA+ usually maintains detail, as well as Sunlu PLA Meta which I am currently testing for smaller prints.
• This was done with 08 Layer height and hides the layers well, but you can most likely lower this to 06 or 04, without support trouble.

-The Cylinder added in the slice is to break of the supports, as tree supports are buggy in both Bambu Studio and Orca, and often create floating disconnected chunks on larger trunks.

Let me know If you liked it, as well as any questions or miniature prints you might need help with in the comments. If this gets enough interest I'll upload more of my sliced miniature files.