这个模型是为了改造中国产“金正”牌食品烘干机，用于做为烘干3d打印耗材的高性价比。

这个模型仅仅适用于尺寸为：26.3cm*20.2cm长方形烘干机设备，模型已经分件，接口处榫卯结合，牢固可靠，左右两边设计了凸起，可以很方便的拿起每一层。

适合P1,X1,A1等型号打印机直接打印，请使用ABS或者PETG等耐温70摄氏度以上材料打印，请注意测试打印机公差，以免装配困难！

一次可以烘干5卷耗材，在3小时内可以把湿度降低到百分之30，建议长时间不使用的耗材烘干时间为6-10小时彻底烘干后密封保存，潮湿耗材打印前烘干3-5小时左右会有很好的打印结果。

本人不对改造烘干机造成的一切结果负责，请你为自己的自愿行为负责，本模型不可做为商业用途！

This model is designed to retrofit "Jinzheng" brand food dehydrators from China for cost-effective drying of 3D printing consumables.

This model is only suitable for the dimensions of a 26.3cm*20.2cm rectangular drying machine. The model has been divided into parts, with dovetail joints at the interfaces, ensuring sturdiness and reliability. Protrusions are designed on both sides for convenient handling of each layer.

It is suitable for direct printing with P1, X1, A1, and other models of printers. Please use materials such as ABS or PETG with a temperature resistance of over 70 degrees Celsius. Pay attention to testing printer tolerances to avoid assembly difficulties.

It can dry 5 rolls of consumables at once, reducing humidity to 30% within 3 hours. It is recommended to dry consumables not in use for 6-10 hours for thorough drying before sealing for storage. Pre-drying damp consumables for approximately 3-5 hours before printing will yield optimal printing results.

I am not responsible for any consequences resulting from modifying the dehydrator. Please take responsibility for your voluntary actions, and this model cannot be used for commercial purposes!