hydroponic planter for sprouts
hydroponic planter for sprouts
Boost
4
4
1
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.6 h
2 plates
Open in Bambu Studio
Boost
4
4
1
0
5
5
Released
Description
This is a planter i designed in onshape. it takes two hours to print and 80 grams in total. supports are on it is normal supports and there are 13 grams of support. i used bambu labs pla white basic for the outside and bambu labs black pla basic for the inside.
Comment & Rating (1)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
supports a little bit tough to get out, but not too bad with a flathead screwdriver
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld