GIF
Print Profile(2)
PLA - 0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
PETG - 0.2mm layer, 2 walls, 15% infill
Designer
1.5 h
1 plate
Boost
3
12
1
1
6
8
Released
Description
I designed this for a coworker who wanted a stamp dispenser that would also peel the stamp as you pull the roll. There are 2 pieces that have a snug sliding fit. Thread the empty roll through the top 3 slots as shown and stow the roll inside the base. As you pull the roll it will peel the stamp so that you can grab and stick it. Pictured print is PETG.
Comment & Rating (1)
All
Boosted
Print Profile
PLA - 0.2mm layer, 2 walls, 15% infill
Printed on a X1c with PLA. Fantastic results! Clean lines, strong build, and PLA material looks sharp. Great printer for detailed prints
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld