The original image is not from me and i have no intentions of selling this filament painting.
It is 100% fanart made for Berserk manga fans.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA BambuLab Basic Black
• PLA+ Sunlu Gray
• PLA BambuLab Basic Gray
• PLA Overture Light Gray
• PLA BambuLab Basic Jade White
• PLA BambuLab Basic Black
• PLA Overture Red

Swap Instructions:

• Start with Black
• At layer #9 (0.8mm) swap to Sunlu Gray
• At layer #13 (1.12mm) swap to BambuLab Gray
• At layer #18 (1.52mm) swap to Light Gray
• At layer #19 (1.6mm) swap to White
• At layer #22 (1.84mm) swap to Black
• At layer #23 (1.92mm) swap to Red for the rest.

Enjoy my work? Support me by joining my club. Tier 1 offers exclusive models, while Tier 2 allows you to sell my 3D printed artwork.