Voronoi Hex Circles swatter by Lossamoal

Lossamoal

Household>Other House Models

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

Voronoi 0.2mm layer, 2 walls, 15% infill

Designer

1.7 h

2 plates

5.0(1)

Hexa 0.2mm layer, 2 walls, 15% infill

Designer

1.7 h

2 plates

3.0(2)

Circles 0.2mm layer, 2 walls, 15% infill

Designer

1.6 h

2 plates

Boost

Released

Description

C'est la saison!!!!

A vos armes, prêts à dégainer!

Ce modele décoratif est à imprimer en quatre pièces et s'assemble avec deux points de colle.

Imprimé en PLA, ce qui lui permet d'être très flexible et non cassant.

Mon prototype a déjà fait de nombreuses victimes! Elle fait mouche à chaque fois au vu de sa rapidité!

Longueur totale environ 47 cm.

La surface de frappe est d'environ de 12X12 cm.

It's the season!!!!

On your weapons, ready to draw!

This decorative model is to be printed in four pieces and is assembled with two glue dots.

Printed in PLA, which allows it to be very flexible and non-brittle.

My prototype has already caused many victims! It hits the mark every time given its speed!

total length approximately 47 cm.
The striking surface is approximately 12X12 cm.

Comment & Rating (8)

@j4ys0n

i usually don't complain but why would you create overhangs like this and then not at least give some tips on how to print it successfully? just creates a bunch of waste. anyway - i can't rate it because it won't print successfully. tried a few times.

The designer has replied

@user_636480210

Hi, I have printed this model several times for myself and my family with success. The overhangs mentioned print very well thanks to the supports of my printing profile. Indeed, if you only download the stl files, you will have to configure the printing with your slicer and therefore determine the speed, layer height, number of walls, printing sequences, etc...

@user_3985444252

Print Profile

Hexa 0.2mm layer, 2 walls, 15% infill

Bed Adhesion Issue

The designer has replied

@user_636480210

The bed adhesion problem is not due to the model. I printed my three print profiles without any problem on my X1C, using a smooth PLA platen, and of course a little glue.

@user_3985444252

Replying to @user_636480210 :

i tried it 3 Times on textured plate ..

@user_636480210

Replying to @user_3985444252 :

Avez-vous essayé avec un radeau pour l'adhérence?