Creality K1/ K1C 32mm hose connector

Creality K1/ K1C 32mm hose connector

Boost
2
0
0

Print Profile(0)


Add the first print profile to earn points

Boost
2
0
0
0
5
0
Released

Description

Hose connector for the Creality K1C to a 32mm hose to lead the exhaust air from the printer to the outside. The holder is attached to the back of the printer instead of the activated carbon filter. The activated carbon filter can still be used in this connector.

If an external fan/extractor is connected, you should consider removing the internal fan or at least disconnecting it from the mainboard so that this fan does not act as a dynamo.

The normal version has a pitch of 60°, the short version has a pitch of 50°. I was able to print both versions without support in the slope. I only used the support in the corners of the base.

--

Einfacher Schlauchanschluss für den Creality K1C an einen 32mm Schlauch um die Abluft des Druckers nach aussen zu führen. Die Halterung wird einfach anstelle des Aktivkohle-Filters hinten an den Drucker angesteckt. Der Aktivkohle-Filter kann in diesem Anschluss weiter verwendet werden.

Falls ein externer Lüfter/Absaugung angeschlossen wird, sollte man bedenken interenen Lüfter auzubauen oder mindestens vom Mainboard trennen, damit dieser Lüfter nicht als Dynamo fungiert.

Die normal Version hat eine Steigung von 60°, die kurz Version hat eine Steigung von 50°. Beide Varianten konnte ich ohne Support in der Steigung drucken. Den Support habe ich nur in den Ecken der Basis genutzt.

 

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more