Stackable Tomato Cage
Stackable Tomato Cage
Boost
34
63
6
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
3.4 h
1 plate
More Resilient 0.2mm layer, 3 walls, 15% infill
2.7 h
1 plate
Boost
34
63
6
6
52
31
Released
Description
A super simple stackable tomato cage. I found about four of these to be a good starting point, especially because the lowest one will probably be mostly in the dirt. A little glue goes a long way with this print, so make sure you get some that can bond to PLA. Also, a stronger PLA will do better outside, and this is probably best printed in white for the same reason.
This project was printed with 3DHoJor Filament, who graciously donated it to my channel for use in various projects.
Comment & Rating (6)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
great print I will make as many as I can got too many tomato plants
0
Reply
Didnt controlled, but holes are on the other side than should be???
The designer has replied
0
Reply
My apologies, this has now been fixed.
0
Reply
Replying to @CFAC
next print was ok, thanks :-)
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld