MASSAGE Happy Feet by DIY Beyond 3D

DIY Beyond 3D

Tools>Medical Tools

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.24mm layer, 6 walls, 30% infill

Designer

18.3 h

3 plates

5.0(2)

0.24mm layer, 4 walls, 15% infill

Designer

4.7 h

1 plate

4.0(4)

Boost

150

165

Released

Description

There are 2 versions:

Version: No mechanical parts no screws, just a base and 4 rollers to print.

Wide and normal sizes.

Bend the base a little to get the rollers on.

2. Version: Uses M5 hex screws

-------------------------------

Update 9th Nov 2023

Some of you reported the rollers not being strong enough and friction too high.

I added another version which has the base in 3 parts.

This Version2 also requires 12 M5x15 mm hex screws.

VER2.ZIP files contains 3mf, and stl files.

Comment & Rating (20)

@zanttux

The print profile is no longer public

while the design is good looking it’s not funtional. Print profile is too weak and sides will flex even from slightest pressure. Also pla rubbing against pla wont last. Mine broke after 1 minute of very slight use.

The designer has replied

@DIYBeyond3D

Thanks for honest feedback. I'm working on improved strength and friction.

@waqasmkz

Great concept but there is too much flex in the base so even moderate pressure and the rollers fall off. Also printer in PLA there is quite Abit of wear from constant rubbing between base and rollers. Don't find it useable. unless this was supposed to be printed in something other than pla for base.

The designer has replied

@DIYBeyond3D

Thank you for your feedback. Increase walls and infill might help not to flex too much.

@intommy

Print Profile

0.24mm layer, 6 walls, 30% infill

look nice, just printed, not tested

@kr0n1k

Version 2 printed nicely and feels strong.

@waqasmkz

The print profile is no longer public

Too much flex in base with PLA so the rollers just fall off even with moderate pressure. also, wear on bump that holds roller in place would be really high. I ended us using the rollers without base.

(Edited)

The designer has replied

@DIYBeyond3D

Thanks for your feedback. But as you can see there is also another version here which needs a little assembly and it has M5 hex screws which act as ball bearings.

(Edited)