This is a 2 part model, which you glue together:

The DeLorean:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Blue Gray Transmission Distance: 3.2
PLA BambuLab Basic Cyan Transmission Distance: 4.8
PLA BambuLab Gray Transmission Distance: 1.6
PLA BambuLab Basic Blue Transmission Distance: 4.8
PLA BambuLab White Transmission Distance: 9.6

Swap Instructions:
Start with Black
At layer #12 (1.04mm) swap to Blue Gray
At layer #13 (1.12mm) swap to Cyan
At layer #14 (1.2mm) swap to Gray
At layer #16 (1.36mm) swap to Blue
At layer #17 (1.44mm) swap to White for the rest.
 

The Logo:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.8
PLA BambuLab Basic Cyan Transmission Distance: 4.8
PLA BambuLab Basic Red Transmission Distance: 4.8
PLA BambuLab Basic Orange Transmission Distance: 4.8
PLA BambuLab Basic Yellow Transmission Distance: 4

Swap Instructions:
Start with Black
At layer #12 (1.04mm) swap to Cyan
At layer #14 (1.2mm) swap to Red
At layer #19 (1.6mm) swap to Orange
At layer #20 (1.68mm) swap to Yellow for the rest.

================================================================================

All the designs i upload, i have to print first, and that's a lot of filament 😬 And filament isn't free..

So, if you like my work you could

buy me a coffee if you like. 😉

https://www.buymeacoffee.com/a.vdh_83

Or a donation via Paypal is also much appreciated.
https://www.paypal.com/donate/?hosted_button_id=3KZUPFUG4KLUL