Summary

These Stick Savers are meant to be attached to the thumbsticks of an Xbox controller to prevent movement (and hopefully any potential damage) while transporting the controller in a bag.

These are a remix of the Joystick Savers by Skylancer. I ended up remodelling them from scratch mainly to smooth out the "wings", but also to build the hex filler pattern into the model so I didn't have to use a specific slicer or mess with removing top/bottom layers and adjusting the filler in the slicer.

I've taken my controller with me on a couple trips and so fare these have done a great job of preventing the thumbsticks from moving at all, so I can only assume they're also preventing potential damage as well.

Print Settings

Printer: 

Ender 3 v2

Rafts:                      

No

Supports: 

No

Resolution:                      

0.20

Infill: 

100%

Post-Printing

After printing, they can be a little stiff to begin with, so I just used them like fidget toys while working and connected/disconnected them a hundred times until they loosened up.