This Hueforge is based on a picture I took in Åre while riding a Skidoo up a trail. An elk appeared and stopped and stared at me, shortly followed by her children who crossed the trail behind her, and vanishing off into the white.

Fyrby Additive holds a commercial Hueforge license.

Colours

I used the following colours in this print, but any black, white, light grey and dark blue will probably work:

• PLA BambuLab Basic Black
• PLA+ eSun Dark Blue
• PLA BambuLab Basic Gray
• PLA BambuLab Basic Jade White

Printing

There is a pre-configured profile for Bambu studio available as well as the separate STL if you want to do it manually. This Hueforge is setup to use a 0.2mm nozzle and expects a 0.1mm bottom layer and a 0.08mm layer height with 100% infill and 1 wall. The Hueforge Describe follows:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.1mm

The Model is 114x152mm in size
You may print at higher layer heights below the Min Depth of 0.26mm
The Max Depth is 4mm and the Actual Depth is 4mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Transmission Distance: 4
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #8 (0.66mm) swap to Blue
At layer #11 (0.9mm) swap to Black
At layer #15 (1.22mm) swap to Blue
At layer #16 (1.3mm) swap to Gray
At layer #17 (1.38mm) swap to Blue
At layer #21 (1.7mm) swap to Jade White for the rest.