4 inch vinyl post cap
Copyright Claim
4 inch vinyl post cap
Boost
5
7
6
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
5
7
6
1
13
15
Released
Description
So I needed a new cap for my railing and took this opportunity to try to reverse engineer one that I bought from a local store. So this is the result. I used pretty much stock settings on the printer, just printed it on its side with supports. I tried it on my post yesterday and it fit a little more snug than the store bought one, but it fit.
Comment & Rating (6)
All
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
Scaled up for 5” post. Saved me a lot as these are expensive to buy.
The designer has replied
1
Reply
I'm glad it worked out for you. Thanks for the rating and the boost! :D
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
I scaled them to fit my wife's rose arch, they worked perfect
The designer has replied
1
Reply
That's great, I'm glad it worked out for you. Thanks for the rating.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thanks for the rating
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld