Silica Gel Container - Small & Medium
Copyright Claim
Silica Gel Container - Small & Medium
Boost
27
52
24
Print Profile(2)
Medium | PLA 0.2mm layer, 2 walls, 15% Gyroid infill
Designer
58 min
1 plate
Small | PLA 0.2mm layer, 2 walls, 15% Gyroid infill
Designer
44 min
1 plate
Open in Bambu Studio
Boost
27
52
24
5
71
52
Released
Description
Two sizes of Silica Gel containers - Small and Medium
Small is 20mm high
Medium is 32mm high
For comparison the usual silica gel container models are around 50mm high.
Comment & Rating (24)
All
Print Profile
Small | PLA 0.2mm layer, 2 walls, 15% Gyroid infill
Small container printed great! Holds 16.6 grams of Wisesorb indicating silica gel beads. I use one in each of my 4 liter filament roll storage boxes. It’s a bit overkill but that’s okay. I replaced the silica from the trays in the ams with two of these and the humidity is at 10%.
For reference, only 1.1 gram of silica gel is needed for each liter of air volume.
The designer has replied
0
Reply
Glad you like it, thanks for the comment! 👍
0
Reply
Boosted
Print Profile
Medium | PLA 0.2mm layer, 2 walls, 15% Gyroid infill
Great project, it works perfectly with silica 3-5mm
The designer has replied
0
Reply
It looks great, thanks for the rating, comment and boost! 👍
(Edited)0
Reply
Print Profile
Medium | PLA 0.2mm layer, 2 walls, 15% Gyroid infill
Printed well thx for the share
The designer has replied
0
Reply
That came out great, thanks for the comment & rating 🙂
0
Reply
Print Profile
Small | PLA 0.2mm layer, 2 walls, 15% Gyroid infill
Works great!
The designer has replied
0
Reply
Glad you like it 👍
0
Reply
Print Profile
Medium | PLA 0.2mm layer, 2 walls, 15% Gyroid infill
good
0
Reply
Boosted
Print Profile
Small | PLA 0.2mm layer, 2 walls, 15% Gyroid infill
The designer has replied
0
Reply
Thanks! Much appreciated 😊
0
Reply
Print Profile
Medium | PLA 0.2mm layer, 2 walls, 15% Gyroid infill
(Edited)
The designer has replied
0
Reply
Thank you for the rating 👌
0
Reply
Print Profile
Medium | PLA 0.2mm layer, 2 walls, 15% Gyroid infill
The designer has replied
0
Reply
Thanks for the five star rating 😊
0
Reply
Boosted
Print Profile
Medium | PLA 0.2mm layer, 2 walls, 15% Gyroid infill
The designer has replied
0
Reply
Thank you for the rating and boost! 👍
(Edited)0
Reply
Print Profile
Small | PLA 0.2mm layer, 2 walls, 15% Gyroid infill
The designer has replied
0
Reply
Thanks for the rating 😊
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld