Lazy Susan by Aaron

Aaron

Household>Office

GIF

Print Profile(4)

All

P1S

P1P

X1 Carbon

X1E

130mm Platform (5 inches) 0.2mm layer, 2 walls, 15% infill

Designer

1.9 h

1 plate

5.0(3)

240mm (9.45in.) 0.2mm layer, 2 walls, 15% infill

Designer

5.9 h

2 plates

5.0(2)

170mm (6.69 in.) 0.2mm layer, 2 walls, 15% infill

Designer

3 h

2 plates

5.0(1)

256mm Max Bed Size 0.16mm layer, 2 walls, 15% infill

Designer

6.2 h

2 plates

5.0(1)

Boost

Released

Description

Layer Height: 0.2mm

Nozzle: 0.4mm

Platform Infill: 25%

Top uses 25% infill. Base uses 40% infill to save on time, but you can increase this to add a little more weight.

Required Parts: 608 Bearings (ZZ, 2RS, Open, Ceramic, etc, any kind will work) You might be able to use printed bearings but I haven't tested it, and wouldn't recommend it because you need the weight from the bearing to keep it stable.

If you want it to be more stable, you could print some TPU feet and put them on the bottom to make it a bit more stable.

I've included profiles for 170mm and 240mm. I have no clue how well they will spin since the bearing is only 8mm wide. Please post feedback if you print these and they work properly. Tolerance should be identical to the 130mm.

If you want a custom size, please let me know and I'll make one for you.

Comment & Rating (17)

@Mochi_Peglin

Print Profile

240mm (9.45in.) 0.2mm layer, 2 walls, 15% infill

it’s like a huge thick record

The designer has replied

@ajbills813

hahaha no wayyy lmao.... Is it too thick? Do you think I should make it a bit more thin for the wide ones? Or do you feel like the thickness necessary for stability?

@Mochi_Peglin

Replying to @ajbills813 :

Im using it to rotate my monitor so the thick plate is perfect for my use case

(Edited)

@ajbills813

Replying to @Mochi_Peglin :

I am so happy people are using this model lol. I am not a designer, I just made this for my wife. Would love to see that... No pressure.

@cbednaz

homie gets negative reviews removed and that's big weird energy

The designer has replied

@ajbills813

MakerWorld made the determination to remove your review for claiming a user error as a print profile defect. There is absolutely nothing wrong with negative reviews that are actually relevant to the profile or model being reviewed. Here is a guide on cleaning your build plate from the BambuLab wiki. I hope it helps you in the future: https://wiki.bambulab.com/en/filament-acc/acc/pei-plate-clean-guide Personally, I use my regular Scrub Daddy with Ajax dish soap and hot water. My plate is good as new afterwards, and I do not have any bed adhesion issues. Happy printing!

@cbednaz

Replying to @ajbills813 :

I use a darkmoon3d ice plate. it has never once had a single adhesive issue except this one print I couldn't rate higher then a 3 cause it failed. then you chirped in saying user error so I lowered it to a one.

@ajbills813

Replying to @cbednaz :

Unfortunately it sounds like you still haven't been able to clean your build plate. I would consult with your plate's manufacturer on instructions on how to clean your print bed :) Good luck!