Masking Tape Holder - Wider with modified back

Remixed by
Copyright Claim

Masking Tape Holder - Wider with modified back

Remixed by
Boost
28
42
9

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1
A1 mini

0.16mm layer, 3 walls, 15% infill
0.16mm layer, 3 walls, 15% infill
Designer
1.6 h
1 plate
4.1(7)

Open in Bambu Studio
Boost
28
42
9
5
92
58
Released

Description

This is a remix of slavik.mis.1984.ve4's masking tape holder with two main changes:

 

  • Added a ledge to the back to prevent the tape from tilting backwards and holding it more stable.
  • increased the capacity so it can hold wider masking tapes (a rescale alone would not have achieved this as it woudl have made the base too big)

It should print well without supports or brims and doesn't need assembly or additional parts. I have found it extremely handy for my woodworking shop use. Thanks to the Slavik.mis.1984.ve4 and hope you enjoy as well.

 

I was also toying with changing the cutting edge geometry to support tougher tapes but found it unnecessary for general masking tapes. Let me know if you think it needs a modified cutting edge.

 

Comment & Rating (9)

Please fill in your opinion
(0/5000)

Boosted
Print Profile
0.16mm layer, 3 walls, 15% infill
great design, printed flawlessly but doesn’t fit my packaging tapes unfortunately just a bit loose
2
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
this fits very loose and the tape consistently falls of, tried 3 different brands and types
The designer has replied
0
Reply
The tape needs to move freely my friend. If it ruba against the plastic enough to hold it upside down, it would be difficult to use. Also please consider the middle hole on the tapes may differ slightly between different tapes. However I suggest you try upscaling the model a tiny amount if you would like a tighter fit while I work on version 2.
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
Used this last week for my garage paint project. Very durable design as I dropped it off a ladder a few times (6-7 feet). the serrated edge allowed me to easily tear off peices quickly. Only problem I have with this is there is no indicator of what the diameter of the holder is before I printed it… the fit is loose with all the tape rolls I have. I had to put 25 layers of masking tape on one side for it to fit snug without the roll popping off.
1
Reply
every roll of tape I have is loose on this, i wish I would have scaled it up to get it the diameter up at least 5mm
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
0
Reply
No more