Pokeball Seperated for easy prints
Copyright Claim
Pokeball Seperated for easy prints
Boost
36
47
7
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
3.9 h
4 plates
Open in Bambu Studio
Boost
36
47
7
0
98
92
Released
Description
Here you will find a pokeball separated into parts to allow easy printing. Each part just requires a little glue to hold in place.
Comment & Rating (7)
All
Print Profile
0.12mm layer, 2 walls, 15% infill
Excellent quality but it has a line on the back
(Edited)
0
Reply
The center part does not have notches on both sides for the two halves of the poke ball to sit into. I made my own model by doubling the half that does have the notch, but I cannot share it as a remix.
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Printed great
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoDerivativesRelated Models
© 2024 MakerWorld