Driver bit holder
Copyright Claim
Driver bit holder
Boost
13
35
3
Print Profile(3)
0.2mm layer, 2 walls, 20% infill
27 min
1 plate
A1 Mini // Both Sides (L/R) // Ultra Smooth // 0.08mm layer
2.1 h
2 plates
P1S // Both Sides (L/R) // Fast & Clean // 0.28mm layer
36 min
2 plates
Open in Bambu Studio
Boost
13
35
3
0
33
26
Released
Description
Bit holder for the spare belt hook screw ion your drill/driver. Holds 5 standard bits using the power of magnets!
Once printed simply press in the magnets, they are snug so may need a good shove.
This is to fit the right side of a driver, for the left simply mirror before slicing.
You will need:
- 5x 5mm diameter x 2mm tall Neodymium magnets.
- 1x mount screw.
- For my Makita I used an M4x20 which is a shade long, 18mm would be better but you'll need to cut one down.
- For Dewalt I believe they use M3 but check on your own tool.
Comment & Rating (3)
All
prints and fits fine
1
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld