Pulp Fiction movie poster fridge magnet
Boost
43
43
13
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
2.9 h
1 plate
Open in Bambu Studio
Boost
43
43
13
3
26
31
Released
Description
Pulp Fiction movie poster fridge magnet.
Measuring 65mm wide by 95mm high by 5mm deep
3 colour AMS print, using black, red, and white.
This needs 4x 8mm diameter by 2mm deep magnets, the magnets push into the model after printing, no need to pause.
NOTE - The magnets are designed to be a tight fit. The best way to insert them is to line up a magnet with a hole then place the model on a hard flat surface facing up, with the magnet on the hard surface, then press down firmly on the model. The magnet will snap into place. Repeat for each magnet.
Comment & Rating (13)
All
I asked for the Pulp Fiction one and wow it came out great hubby loves it.
I think I'm going to have a fridge full of mini movie posters lol
The designer has replied
1
Reply
I'm glad you're hubby likes the model!
Not sure if you've seen them but I have done 2 other magnets based on pulp fiction... And a Christmas tree ornament too... You (or hubby) might like them :-)
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Another winner!
The designer has replied
1
Reply
Thank you!
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
I like it, thank you !
0
Reply
Boosted
Fantastic models! Thanks!
The designer has replied
1
Reply
Glad you like the model and thanks for the boost!
0
Reply
Boosted
Print Profile
0.08mm layer, 2 walls, 15% infill
Great print! I'll be making TONS more of these!
The designer has replied
1
Reply
Glad you liked the model and thanks for the rating!
0
Reply
Boosted
Print Profile
0.08mm layer, 2 walls, 15% infill
Mega
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thanks for the rating, I appreciate it
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld