I designed this under desk headphone holder for my Sony wireless headphones, however it should also fit headphones with a band width up to approximately 32mm.
It features a curved hook so as not to leave an indent in the headphone padding and can be mounted with 2 small screws (up to 4mm diameter). 6.5mm holes have been left in the hook to allow for a screwdriver to pass though and allow for fitting.
To hide the seams best I would suggest setting them to “back” and then rotating the object so that the bottom aligns to the back of the plate.
Print time: ~1hr
Print settings used:
Brim: None
Support: None
Infill: 30% Triangles
Layer height: 0.2
Walls: 3
Bottom Layers: 3
Top Layers: 3
Post Processing: None