T-rex with gnomes

Copyright Claim

T-rex with gnomes

Boost
9
12
5

Print Profile(1)

All
A1

0.2mm layer, 3 walls, 5% infill
0.2mm layer, 3 walls, 5% infill
Designer
6.1 h
1 plate
5.0(2)

Boost
9
12
5
2
10
4
Released

Description

I try to slice the models with minimal filament waste and minimal support.

 

Comment & Rating (5)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 3 walls, 5% infill
turned out great!
The designer has replied
1
Reply
yay I’m glad it worked for you
0
Reply
these look great! I printed on a P1S with PETG. the only flaw I see is on the back left of the T-Rex below the gnome hand. both had some line issues there but are very minor. totally will print this again!
The designer has replied
1
Reply
thank you I’m glad it printed good for you and that you’ll print it again. I was going to color it so it can be printed multi color but figured it would be easier to just do one color and let the person chose to paint it or not.
0
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
0
Reply
No more