Puffy Vehicles - x-wing
Copyright Claim
Puffy Vehicles - x-wing
Boost
54
73
10
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
1.3 h
1 plate
fixed support breaking Xwing issue - 0.2mm layer, 3 walls, 5% Gyroid infill - A1 mini friendly
1.2 h
1 plate
Open in Bambu Studio
Boost
54
73
10
1
77
71
Released
Description
if you like this kind of stuff consider supporting me on my Patreon www.patreon.com/wekster
Comment & Rating (10)
All
Print Profile
fixed support breaking Xwing issue - 0.2mm layer, 3 walls, 5% Gyroid infill - A1 mini friendly
From work, looking at the built in camera, it looks like this was a success! It will require cleaning but looks great!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
printed with Sunlu pla+. I refined the profile because with Sunlu filament is better to print slower.
Holding bad the x-wing while I was removing supports, I broke a pin of one cannon 😭. Despit this, the miniature has been printed well. Now I’m cleaning better for the next process: painting 😏
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
cute little print , supports were a bit of a bugger
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
nice
0
Reply
Boosted
Print Profile
fixed support breaking Xwing issue - 0.2mm layer, 3 walls, 5% Gyroid infill - A1 mini friendly
My son loves it
0
Reply
I love this design I wish I can like make it like you ❤️❤️❤️❤️❤️❤️❤️❤️❤️❤️❤️❤️❤️.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Support Issue
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld