I wanted a nozzle level mount for my trust tyro HD webcam that did not stick out too far from the front of the frame of the printer.

The design uses the mounting bar from the original mount and latches into the aluminum channel and locks into place using a pin mechanism.

I use this with a Creality Ender 5 S1 but it should fit any printer using a stable cube design with 20mm rails.

Support is required for the overhanging mount, I personally used organic tree supports and painted the placement.

When you fit the camera to the mount make sure to put the hexagonal end of the original mounting bolt on the chamfered side of the mount so it with "bite" and not spin when tightening the screw on the other end.

As a bonus I have included some simple loop cable clips I designed to fit the aluminium profile of my ender 5 S1.

Print Time: ~ 1hr 10m

Print settings used:

Brim: If you struggle with bed adhesion then you may want this for the latch part

Support: Yes for the over hanging part of the mount (tree support recommended)

Infill: 20% Cubic

Layer height: 0.2

Walls: 3

Bottom Layers: 3

Top Layers: 3

Post Processing: Just removal of the tree support