DO NOT CHANGE THE Z-HEIGHT. For ease of use, i suggest unchecking the “UNIFORM SCALE” and change X and Y Percentace only when editing size;

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
PLA BambuLab Matte Charcoal Transmission Distance: 0.6
PLA BambuLab Matte Scarlet Red Transmission Distance: 2
PLA BambuLab Matte Lemon Yellow Transmission Distance: 4
PLA BambuLab Matte Ivory White Transmission Distance: 3.5
This print uses 4 unique filaments

Swap Instructions:
Start with Charcoal
At layer #15 (1.28mm) swap to Scarlet Red
At layer #18 (1.52mm) swap to Lemon Yellow
At layer #22 (1.84mm) swap to Ivory White for the rest.